Lay the liner out flat in the pool.   

by Pool Builders on 08-13-2011 in Articles

Go to the North corner of the pool and slip the beaded edge of the liner into the grooved edge of the bead track that sits on top of the pool wall. There are a few simple guidelines that will help steer you away from trouble spots.    Install a Beaded liner on a sunny day. The purpose of this technique is to distribute the stretch evenly. Once you start filling the pool with water you are past the point of no return. It does not have to be perfect yet€¦€¦the goal is to have the bottom of swimming pool blanket the liner centered and laying flat with no big wrinkles. Lastly, attach the liner into the groove at the remaining open spots. Re groom the bottom of the pool with fresh bank sand (also called pool sand). Now you should attach the liner at the NW, then SW, then NE, and SE corners. Do not fill the pool with water until you have the liner where you want it. Full of water. Check the pool every 20 minutes until the pool is 2ft. Push out some of the bigger wrinkles on the floor of the liner. (If the seam of the liner does not fit exactly to the edge of the perimeter of the pool, it is OK.) The goal is to center the liner with respect to the pool, even though the liner seems to come up short. When the liner is completely attached, smooth out the wrinkles at the bottom of the pool liner. As the puddle of water grows, push the wrinkles out of the liner towards the pool wall. Remember, having a few helping hands is good advice. The goal is to alleviate or lessen the tightness in the corners. At this point the liner will be attached to the Bead Receiver (bead track) in 4 spots. When the water reaches swimming pool liners the 2ft. While it is filling you should continue to stretch the liner by hand towards the pool wall. Make sure that you continue to fill the pool in hot and sunny (daylight) hours. Then go to the South corner and do the same. Finally go to the East and West and repeat. If the size / measurement is correct, unroll the liner out in your yard and let the warm sun hit the liner for at least 30 minutes. Any tightness in the corners will be stretched by the weight of the water. If it does you can put it back in and continue to fill. Preferably on a day that is 75 degrees or warmer. Opened boxes are usually not returnable. If it is a tight fit, this is OK€¦€¦just lean into the liner with the weight of your body from the inside of the pool, to stretch the top of the liner towards the grooved edge of the bead track. Prepare the pool before installing the new liner by draining all of the water out of the pool. Credit: Willow Grove Camp@flickrNow you are ready to install the liner. The purpose of this is to combat the common problem or issue: when or if the beaded lip pulls out of the bead track. At this point it is OK for the liner to be taught (or tight) in the corners. Next, start filling the pool with water. You should remain in the pool until the pool is 3€ full of water. Center the seam of the liner with respect to the bottom perimeter of the pool. Point, you then cut the holes for the skimmer and the return. Installing a beaded liner for an above ground swimming pool is very easy. Then remove the old liner.

Leave a Comment

 
List YOUR Pool Business