Swimming Pool Maintenance Guide - A Guide to the Safe and Simple Use of Swimming Pool Chemicals

by Pool Builders on 04-23-2009 in Articles

Whether you are using a spa or pool for the first time, or just starting up for a new season, it is worthwhile taking some time out to consider the steps required to enjoy a trouble free bathing experience.

Get it right first time by following this easy step by step guide.

Set up your pool

1.     Ensure the surfaces are cleaned and that any cracks, leaks or liner damage are repaired.

2.     If your pool is new then it should be commissioned by the installer.

3.     For above ground pools and family inflatable/fun pools follow the manufacturers set up instructions

Cleaning your pool

1.     Remove all leaves, debris and dirt.

2.     Brush the sides and bottom of the pool - take care with membrane liners.

3.     Drained concrete pools can be cleaned with specific cleaning agents.

Painting your pool

* Consult the pool supplier for guidance and advice regarding suitable paint systems, not all are appropriate.

Order the Chemicals you need

If you are a new pool or spa owner an easy way to start is with a starter kit. This will give you all the basic chemical treatments and correct test kit you will need to get started. Starter Kits will include, a Sanitiser , shock treatment, Algaecide, pH balance chemicals and a simple test kit.

Filling your pool

Guidance on pool fill

1.     Dose Chlorine Granules or Non Chlorine Shock. It is advisable to dissolve granular swimming pool chemical treatment products in a bucket of water before adding the mixture to your water. This avoids neat swimming pool chemicals settling onto pool surfaces and is particularly important with plastic liners, as concentrated chemicals will adversely affect the liner surface .

2.     It often helps to stir the water with a pool brush while the pumps are off to ensure an even distribution.

3.     Chemical usage should always be kept to a minimum to assist in maintaining the water balance.

4.     Do not back wash the filter for at least 24 hours to allow the product to disperse. Consult the filter manual to ensure correct operation of the valve assembly.

5.     When full, allow the filtration system to carry out its daily routine.

6.     Test the water, make sure your pH is balanced

Tip- use a water meter when filling the pool for the first time this will give you an accurate water volume (in litres or gallons), useful for calculating chemical dosing.

Testing the Water

* In order for you to enjoy your pool or spa it is important that you test the water on a regular basis and ensure it is kept in good condition. The testing of the pool / spa water will at first seem daunting, however our test kits are easy to use and will give quick accurate results.

Basic Tests

1.     pH

2.     Alkalinity

3.     Sanitiser (Free Chlorine or Bromine)

Visual Inspection

1.     Check the water for clarity, ensure it is clear.

Additional Tests

1.     Calcium hardness

2.     Combined chlorine

3.     Copper levels

Tip

Always record your results and the chemical additions that you make. Keep a note book with the test kit and chemical treatments. Retest the water after the addition of chemicals to ensure you have reached the correct levels.

Tip

  • If the water is cloudy then it is not safe to swim,
  • Bathers cannot see the bottom and may dive in to shallow water!
  • Bathers in difficulty under the water will not be seen!
  • Cloudy water is an indication that there is a problem with the treatment.

Leave a Comment

 
List YOUR Pool Business